The daily cleaning and maintenance of the corrugated sheet forming machine is essential to maintaining the performance of the equipment. The following steps should be followed: Power-off safety preparation: Before cleaning, be sure to turn off the power of the equipment and hang a warning sign to prevent accidental startup and ensure the safety of the operator.
1. Surface cleaning
Use a compressed air spray gun or vacuum cleaner to remove dust and metal debris from the surface of the equipment, focusing on cleaning the roller group, transmission chain, and other dust-prone parts.
Wipe the electric control box and operation panel with a clean rag to prevent oil and water stains from penetrating into the electronic components.
2. Roller cleaning and maintenance
Spray the roller surface with a special cleaner to soften the residual oil and metal powder.
Use a soft brush or copper wire brush to gently scrub the roller groove to remove stubborn dirt, and be careful to avoid scratching the roller surface.
After cleaning, apply an appropriate amount of lubricating oil on the roller surface to prevent rust and ensure smooth passage of the sheet.
3. Transmission system maintenance
Check the chain, sprocket, and gearbox, remove dust and oil, and ensure that the transmission parts are well-lubricated.
Clean and tighten the belt tensioner, coupling, and other parts to prevent looseness from affecting the transmission accuracy.
4. Hydraulic system maintenance
Check the hydraulic oil level. If it is below the warning line, it needs to be replenished in time. At the same time, observe whether the oil is turbid and replace it if necessary.
Clean the surface of the hydraulic pump station and the oil pipe to prevent dust from entering the system and causing blockage or wear.
Waste disposal: Clean the scraps and waste around the equipment in time, keep the working area clean, and avoid waste accumulation that affects the operation of the equipment or causes safety hazards.
Regular deep cleaning: Perform a comprehensive cleaning once a week, and conduct a deep inspection and cleaning of the inside of the equipment every month. Key components can be maintained with professional cleaning agents.
Record and inspection: After cleaning, record the maintenance status, check whether the various parts of the equipment are normal, ensure that there are no tools or debris left in the equipment, and prepare for the next operation.
If you are interested in a corrugated sheet forming machine and are eager to get more detailed information, you are sincerely welcome to contact Wuxi J & R Roll Former for an in-depth consultation.
https://www.jr-rollformingmachine.com/
